#ADPro Problem
Perry,
I recieved my copy of ADPro today(Friday), and while I haven't sent in my
registration card yet, I'm hoping I can get some support early.
I installed ADPro using the included instalation program. When I clicked
on the Workbench Icon for the first time, the screen turned grey and
dropped down for the Alert box. After several (about 15) seconds, the
alert popped up and I got a visit from the guru. Upon reboot, clicking on
the ADPro icon froze the machine. Since I am stubborn this happened
repeatedly. After several attempts, I rebooted into 68000 mode, and
everything seemed to be fine. (I say seemed because I did not do any
exhastive tests at this time, but everything I tried worked, and the
program exited gracefully.)
My system configuration is: A2500/20, 1M Chip ram, 4M Fast ram on A8620
board, and 4M 8UP board, etc. Booting into the 68000 mode costs me 1/2 of
my Fast ram.
I am not positive, but I believe (from memory) that the guru # was
8400000B.00000000. Although I am hoping that you will tell me that this is
a programming problem, I find that hard to believe. TAD never had any
problems with the excellerator board.
I wish I could say that my system has been stable for years and that your
product is the only recent change, but bunches of companies have diluged me
with products in the past few weeks- that time of year ;-). The 8UP board
is less than a week old, and it is the only thing I would think might
effect this problem, though I don't really see how.
Any ideas? Anything I left out? Any help on where I should start looking
to track this problem down will be greatly appreciated.