#Gomf3.0
Allstartup-sequence as manual shows (stack 1000 , run > nil: gomf3.0 ,stack 8000)
then I attempt to copy Gomf3.0 onto disk…the copy goes about 3 secs. then I
get a READ/WRITE error prompt that connot be stopped without re-boot… but
upon re-booting the disk reads fine, no error messages, and there is a file on
the disk of gomf3.0. So believing that Gomf3.0 IS present, I attempt to
intentionaly GURU the Amiga…when I do… I cannot get the GOMF3.0 prompt…
just a standard guru…then I must reboot. I believe that the problem is on my
end and not GOMFF3.0, since I can run it directly from the disk properly… any
possible solutions ???
-John Little