Z-100 AutoCAD ports
30-Mar-88 18:45:14
Sb: #21276-Z-100 AutoCAD ports
Fm: Dale L. Paus 73417,473
To: Steve McCall [ADESK] 73417,2234
No, that's doesn't do it. Once you enable I/O port configuration, ACAD says
"i/o port questions will be asked during device configuration" or some such
message. When you then go to configure a device, the question you're asked
is something like "Available ports are Serial A or Serial B. Enter port (A
or B) <A>: " If you try to enter a hex address, you're rewarded with
"Invalid response. Enter A or B <A>:" and this continues until you either
answer A or B or give up. By the way, if support for this isn't built-in to
the 2.17b config. utility, I'd be happy with an address to patch with DEBUG.