CompuServe Thread

#3ds to video

3 messages in this thread
#38247From: Brian Rudolph [Adesk]Mar 23, 1993 1:46 PM
Even though I have access to some nifty equipment, I have had to try for low cost solutions for certain projects as well. One trick that I have done to make my walkthrough animations look better is to render the first and last frames of the animation on a targa or whatever at a high resolution and true color (you can send a still image out to tape without a frame controller or special deck), and put those frames at the beginning and end of a VGA animation put to tape through a VGA>NTSC converter. The still images are only when people notice detail and colors and stuff, when the picture is moving you can get away with murder (at least to a point…). Hope this helps, or at least gives you some ideas.
#38270From: Robert J.P SmithMar 23, 1993 10:06 PM
Brian, I was working over the weekend with the idea also of increasing the resolution of the first few seconds of my "test" walkthru but as far as I could see after looking at it over and over more than a dozen times.. no major difference so I'll keep trying with the .flc format rendered at 512×480 .. Yes there are less colors than a .TGA file and it does play back at a slower pace than if I had done it frame by frame.. But I asked today a Mtl company how much they charged for transferring .TGA frames to S-VHS then to VHS video.. I as quoted 1.50 per frame ! ( Shreik!!!) I'll keep practicing the transfer from HD to VCR and use slightly lower res.. P.S ( they were planning to go .tga to Mac..Mac to Unix..unix to Betacam.. Betacam to S-Vhs or VHS .. what a circus..but I could have 900 frames done in a few hours! but at what a cost..
#38325From: Brian Rudolph [Adesk]Mar 24, 1993 12:10 PM
Acually, I think you may be slightly confused as to what I was saying about the first and last frames being at a higher resolution. I meant to say that you put in the images at a higher resolution whenever your camera motion is still (which is usually at the first and last frames, plus wherever you pause in the animation to see a detail). If you put a truecolor still next to a vga still of the same image, even at the same resolution, I guarantee that you will see a difference. -BDR