Tony
Thanks for the hints. It's 071 490 8881. I could do with a hard drive and
Autopilot, I'm used to using OzCIS on a pc laptop and it's an awful lot cheaper
and easier than Term (good as it is).
BTW, I'm on the pc now and it works fine at 14400. Looks like it could be the
serial prefs eh?
Keith
Keith,
I tried the 14400 node. It works fine. My Workbench serial prefs were at
19200 baud, no parity, 8 bit, 1 stop bit.
My Term serial prefs had to be DIFFERENT however – 7 bit, even parity, 1
stop bit, 19200 baud ( connects at 14400 baud ).
I usually use AutoPilot.
best,
Tony.
Driving my deck on AutoPilot