Supra 2400 Plus + Whap!
5 messages in this thread
I am using an MNP modem. For some reason, I must manually enter a CR at the
end of each command that Whap issues. I have ^M set for the EOL character
in the Whap parameters. Any ideas? This is a Supra 2400 Plus modem.
Cheers,H Paul (WA1OMM)
Paul:
Whap doesn't like my MNP modem either (Applied Engineering DL 2000), even
if I disable MNP.
I have used an MNP modem on CIS and with Whap! for two or three years, the
Practical Peripherals PM2400SA. I did NOT check the MNP box on Whap!, but
had no troubles at all using the modem.
Now, I'm using the PPI PM9600SA, with v.42bis, and that works with no
problems, too.
Betty
Betty:
Well, that's curious. Another member (Rob Kummert) left a message recently
that he's had the same exact problems with Whap and the AE DL2000 w/ MNP.
Roger
Roger, I missed the start of this thread, but I have the supra 2400 plus
running with Whap!. I've used it with MNP checked and not checked. Since
I only have access to a 2400 bd line I think it makes no never-mind.
('Cmon Betty – don't get on my grammar ;^} ) I now run without the mnp
checked since if I brought up BT from Whap! with it checked, BT would try
to operate in 9600 bd and thngs would go south quick. Other than that the
combination runs flawlessly.
BTW, I am running with the modem using factory defaults.
wmc