CompuServe Archive

I just bought an SX-1 expansion unit for my CD32. However there was no warranty card or serial number enclosed. The company that makes the unit has a disconnected phone. My problem now is that after running the unit it kicks out the whole system after 45 minutes or so.…

Can this be done with software, or does it need to be installed physically? Ed Kercado

I haven't tried it on an A2000, I should have done so. Thanks for your time and I'll let you know the outcome. Ed Kercado

I have a problem reading high density drives. My set-up; A1000 with a rejuvenator board Kickstart 37.300 & AmigaDos 2.1 2meg Agnes and 5.5 fast ram memory Chinon high density drive (made for the A2000) installed in an A1010 floppy drive case used as DF1: I get an Error validating…

I have a problem reading high density disks. My set-up: A1000 with a Rejuvenator board 2.05 ROM in a ROM switcher (with a 1.3 ROM) AmigaDos 2.1 SupraTurbo28 Quantum 40 meg hard drive & DataFlyer controller 2 meg agnus chip & 5.5 fast ram expansion memory Chinon high density floppy…

Thanks, I was successful. Ed K

Bill, My problems were 1st, the install disk had a read error and could not be disk-copied and 2nd, during fade the signal lock broke down. The read error turned out to be in a text file so I could use the software, but I couldn't do anything about the…

I would like info on any upgrades to G-Lock. Thank you.

I have come into a 5 1/4" Amiga drive (1020). Is it possible to use it as an Amiga drive or is it an IBM file copier to/from Amiga?