This is an archive of CompuServe forum messages from 1985 to 1995, as saved in transcripts by John Foust.
Search Results (12 messages)
PAR BOARD WANTED
Message #196684
We're looking for a used PAR board. If you have one for sale, please let me know. Helen
PAR Board Wanted
Message #196042
We're hunting for a used DR-2100 PAR Board. Leave a message if you have one. Helen
Hi, I'm interested in your PAR. Cost? Helen
3DS & Camera Roll
Message #194046
Anne, Thanks for the info. I'll check it out. Helen
Bob, Thanks for the advice. It sounds like the best approach is to roll everything as you suggest so that the plane in which you want to move the camera is parallel to the top viewport. Then start the animation. We're going to try it on the next project. Helen
#3DS & Camera Roll
Message #193391
Bob, Thanks a lot for your speedy reply. We'll be checking out your suggestion and will let you know the results. Thanks also for the info regarding messages. Helen
3DS & Camera Roll
Message #193313
Hi. This is a repeat of an earlier message to which I received one answer that, unfortunately, is lost. Thanks to whoever sent the answer. I'd really appreciate it if you would send it again. The question is: If you fix a camera target and then move the camera in…
#3DS, rel. 3 and 4
Message #192972
Hi. My question is: If you fix a camera target and then move the camera in a plane parallel to the top viewport, the camera does not roll. However, if the camera is moved in another viewport in its plane, the camera rolls while being moved. How can you keep…
Jonas, Thanks for your reply. I'll check out the file you suggested. Helen
Nik, Thanks for your reply. I think I'm stuck replacing the controller board. Darn!
3DS3
Message #101924
Has anyone found a fix for the W83757 chip on the controller board that brings up the "SentinelPro must be plugged into parallel port" message, short of replacing the controller board???
Thanks for the information. I'll check it out. HT