CompuServe Thread

#Install boots PC

4 messages in this thread
#51477From: Andy DavidsonJun 26, 1993 9:39 PM
I have two Microsoft CR-ROM products — Bookshelf and Developer Network — that I cannot use, since as soon as I run install from the CD-ROM, my PC reboots. The drive is an Hitachi CDR-1750, the SCSI adaptor is the Adaptec 1542B and I am using the CorelSCSI driver. The other CD-ROMs I have work correctly. Does anybody have any idea where I start looking for this problem? andy
#51483From: kevin kellyJun 26, 1993 11:45 PM
Bookshelf is sorta notorious for not being compatible with complex systems and, especially, TSRs. Try creating a minimal boot disk with just the bare necessities, like your CDROM driver and mscdex, and nothing else. If the problem evaporates, it becomes a tedious bit of detective work to see which programs and/or drivers are offending your 2 errant CDs. Since you only have a couple of problem disks, this kind of problem is the most likely. Best of luck…
#51631From: Andy DavidsonJun 28, 1993 8:11 PM
Thanks for the suggestion, but even pared down to a minimum boot disk — only the SCSI code, QEMM, and the CD-ROM extensions, Microsoft Bookshelf and Network Developer install program (setup) reboot the system. And the problem is now wider than Microsoft code. I just got the CorelDRAW! 4.0 upgrade and tried to install it from the CD-ROM. Same problem occurs. Help!!!!! andy
#51638From: kevin kellyJun 28, 1993 9:10 PM
Last likely trick in my bag would be to get rid of QEMM and the Network Developer (whatever that is) too; may not accomplish much at this point, but settin' up a floppy or alternate config/autoexec files doesn't take too long. If you are running on a net, you may need to get it gone temporarily or try the /S switch on mscdex. From there, I'd pull all absolutely unnecessary boards out of your system and try again. It sounds extreme, but it takes about 5 minutes and can eliminate a squirrel or two. Then I'd run a good diagnostic on the system (easy commercial programs like Norton v7.0, prior versions don't have the diagnostics, are available or borrowable), maybe before and after pulling boards; and, yes, I'd run a virus scan. Several shareware anti-virus programs are available on CI$ or from almost any BBS; MacAfee's virus program is well-regarded. Best of luck!!